Please enable JavaScript to view this site.

Introduction

When you measure the association rate of a radioligand, the rate at which the binding equilibrates depends not only on the association rate constant and the amount of ligand you used, but also on its dissociation rate constant. (Why?) The only way to fit the association rate constant by analyzing association data from one concentration of radioligand, is to constrain the dissociation rate constant to a value you determined in a different experiment.

Alternative methods of determining an association rate constant are to globally fit data obtained with multiple radioligand concentrations, or to analyze an experiment that measures both association and dissociation rate sequentially.

Step by step

Create an XY data table. Enter time in minutes into X, and specific binding into Y.

From the table of specific binding, click Analyze, choose nonlinear regression, choose the panel of Kinetics Binding equations, and choose Association kinetics - One conc. of hot.

You must constrain Hotnm ([radioligand] in nM) and Koff (dissociation rate constant, in inverse minutes) to constant values.

Model

Kd=Koff/Kon

L=Hotnm*1e-9

Kob=Kon*L+Koff

Occupancy=L/(L+Kd)

Ymax=Occupancy*Bmax

Y=Ymax*(1 - exp(-1*kob*X))

Interpret the parameters

Kon is the association rate constant, in units of M-1 min-1

Koff is the dissociation rate constant, in units of min-1

Kd is the equilibrium dissociation constant, in Molar, computed as Koff/Kon

Bmax is the maximal binding at equilibrium, extrapolated to maximal radioligand concentration, in the units used to enter the Y values.

Notes

© 1995-2019 GraphPad Software, LLC. All rights reserved.